Oraphim LogoOraphim
Beta soon

Editing

Multicam

Use multicam in Oraphim with a production-safe workflow, practical example, verification steps, and common failure checks.

Updated August 27, 2026

Multicam

This page explains multicam in the current Oraphim Windows workflow.

Workflow

  1. Open the workspace or panel named in this guide.
  2. Select the media item, clip, layer, node, or project resource you intend to change.
  3. Make one visible adjustment at a time.
  4. Preview before and after the change.
  5. Save the project after a meaningful milestone.

Practical example

Apply the feature to a short test section first. Once the result is correct, repeat or extend it through the complete timeline or composition.

Verify the result

Play through the affected range, inspect the first and last frame, and confirm that the change survives save and reopen. For delivery-related work, inspect the rendered file as well.

Use Multicam in a production project

  1. Open Edit workspace and select the intended clip, edit point, track, or timeline range.
  2. Establish the correct input state first—timing, media link, layer/node enable state, project settings, or source selection as relevant.
  3. Apply or adjust Multicam with one clear goal. Change the smallest set of controls needed to reach that goal so the result remains understandable and reversible.
  4. Review the complete affected range in context. Scrub difficult frames and also play at normal speed when motion or audio is involved.
  5. Save a named milestone before moving into another major operation, especially after graph changes, tracking, AI processing, relinking, simulation, or delivery setup.

Practical guidance

Multicam work is easiest when angles share reliable sync. Confirm synchronization first, then switch angles while preserving the underlying source and audio strategy.

A useful test is a short 5–10 second section containing both an easy case and a difficult case for this feature. Tune against the difficult moment without breaking the easy one. If two approaches are plausible, duplicate/version the project state and compare them rather than stacking both together blindly.

Verify the result

  • Play through the edit at normal speed and check upstream/downstream timing.
  • Toggle/bypass the operation where possible and make sure the change you intended is actually responsible for the result.
  • Check selection, visibility/mute/solo state, node connections, track locks, range, and source identity when the result appears missing.
  • Save and reopen before treating a complex setup as reusable.
  • If this feature changes final pixels or audio, render a short review and inspect the file outside Oraphim.